Imagineminis

Armored Elekk Mount (WIP)

Added 2021-08-25 14:57:32 +0000 UTC

Hello everyone!

Today I have finished the Armored Elekk Mount. I have hollowed and sliced, soon I will be test printing.

I will add in the final version an Idle pose with loose armor parts so you can delete those parts and customize your own or print as it is. I will also add a version with loose parts and Head so you can change head pose and add variation if you wish. Those will not be hollowed, I had a bad experience with the unmerged wild Elekk.

While it is printing I will also split a few armor parts to print and glue over the wild elekks, making them also mounts (I have already tested the saddle.

On the modular Draenei: I have done the Legs and Torso (decided to make a flat joint there), it won't have a lot of mobility but it will work. The reason for that is because I did not like the ball joint I made. About the arms, I am having problems deciding how to make the character hold a Two hand Weapon. Heads I am working on different types of helmets also I have not decided yet if I let the joint hole on the head and attach the neck to the torso or leave the hole on the armor and attach the neck to the Head (like space marines).

Delay note: I was intended to do this print earlier but I had some technical issues with my PC and for some unknown reason it did not turn on. The CPU was doing the cooler noise but got no image, I tried rebooting it many times but it was useless. Later I removed the HDMI from the video board and plugged it directly at the Mainboard, it worked. So I thought my video got problems and went after the warranty, once I found I tested it again and it worked fine as if nothing happened.

Feel free to leave comments below, with your opinion or suggestion.

Best regards,

Ivo