CYBER DRAGON
Added 2020-05-20 17:20:02 +0000 UTCCyber Dragon on the drive. The pre-supported file is in one piece.
Honestly, I like this model, but he is a bonus, and he was an old model that I made last year. It was a nightmare to place the supports (thanks Jeremy!).
The base is too large (like a cube) to slice it correctly, and cut the explosion would make a srange rendering. That why I have decided to print him in one piece. I could cut the wings, but that not change the size of the dragon (again , because of the size of the base)
So I will give you a sliced version for FDM printers, if you want to print him bigger.
I hope you will appreciate this model, good print my friends!
Comments
Any news on the FDM version? I tried to slice it myself to print a bigger version on the ender 3, but most of my prints so far were Inperfect. They did not fail per se, but many of the spikes have parts of them missing. Also I had to slice the main body up to 4 parts (base, ... upper base, dragon body, neck and head) and the wings as well to fit it on the printer.
2020-06-04 19:03:05 +0000 UTCWhat is the rough measurements(mm) on the Cyberdragon?
Goodmead
2020-05-22 14:14:16 +0000 UTC
