NokiMo
yasashiikyojinstudio
yasashiikyojinstudio

patreon


Flail Snail Release!

Doing what a snail does this fella took his time getting here but he finally made it!

This is a pretty sizable monster which just makes it that much cooler on the table, it also comes with a version withdrawn into the shell because apparently it does that and cries when all it's flails get cut off?! 

As always the 32mm and 54mm versions (including pre-supported) as well as paper minis, a stat sheet and online VTT tokens have been added.

I actually done a fancy spin render this time if you want to check it out a bit closer.

Flail Snail Showcase 

-------------------------

New stuff can now be easily found here. Enjoy!

Collection/_LATEST

Collection link and current password

Pre-supported collection link and current password

Digital Hero link and current password 

Flail Snail Release! Flail Snail Release! Flail Snail Release! Flail Snail Release! Flail Snail Release! Flail Snail Release!

Comments

What was the difference? just thicker supports?

Yasashii Kyojin Studio

I had to end up adding my own supports, as it continued to rip away each time. However on the 4th attempt, using my supports it printed beautifully! I cant wait to paint him up.

Other files are working though? Hmmmm maybe a slight bump up in exposure would help keep the connection points stronger

Yasashii Kyojin Studio

I have attempted the print twice and each time the snail end up on the FEP and the supports print perfectly. I slowed my lift to 1mm p/sec, other prints are doing good. I imported the recommended support cfg as well. I was wondering if anyone else is having similar issues and may have some advice.


Related Creators