Tips and Tricks - Printing settings
Added 2023-01-14 14:26:41 +0000 UTCHi boys!
I just received a message from a subscriber who is having trouble printing templates.
I state that I'm not a technician and I found the right settings for my printer by asking friends for advice and trying to print (many of them went very badly! :D) until I found the best settings for my printer, an Elegoo Saturn.
Having said that, I am attaching the settings that I use for my printer, so that you can compare them with yours and, if necessary, modify them and find better performing solutions.
I hope this is useful for you and to improve the quality of your prints!
As always, let me know if they help you!
Comments
Joe if you made some screenshot I'll publish in the home! Remember to say what printer you use!
PgGasta
2023-01-15 12:49:08 +0000 UTCYou're welcome!❤️
PgGasta
2023-01-14 17:03:04 +0000 UTCThis is so helpful, thank you all for the tips!
TatanGaultier
2023-01-14 16:39:12 +0000 UTCI go slow with a lift speed of 50mm/min. Yes, it takes longer but less stress on the model and fewer failures. Retract speed 150mm/min. 6 bottom layers. 35sec bottom layer exposure time, 10 transition layers. Lift distance 10mm. 12 sec light off delay. I use elegoo plant-based grey resin almost exclusively with a 2.7 sec exposure time.
Joe Vitale
2023-01-14 15:43:43 +0000 UTC
