Lulu wip02
Added 2022-09-07 17:44:29 +0000 UTCHello!
Here's an updated Lulu model for you. I believe I finished sculpting everything today, and now I just need to adjust a few things for the NSFW version.
She was a big challenge, I must say! The belts you see in the images were my third attempt at this part of her dress. I tried to make them as solid as I could, to avoid causing trouble during painting, hiding parts that would be difficult to reach with a brush, and I hope I didn't miss any area.
She's almost ready for the 3D printing preparation phase. I hope you like the result so far :)
Lulu will be released on October 3, 2022.
Comments
Hm, that's a good observation. It does look a bit thick. I was just finishing exporting everything for Lulu, but I reduced her neck's width a little now. The renders will still show it as before, but the actual printable version will have it adjusted.
Torrida Minis
2022-09-13 19:02:52 +0000 UTCBeautiful work, only her neck looks a bit too thick in this render π€
Domi Schell
2022-09-13 18:10:31 +0000 UTCThat doesn't sound like too much work, so it should be possible, but I'm having troubles with the 3D printing preparation and I don't know if I'll have time to make a cactuar :(
Torrida Minis
2022-09-12 20:12:06 +0000 UTCExcellent work! Maybe in the nsfw, you could add thebpossibility to put a cactuar instead of a moogle :D
Oliver Leytens
2022-09-12 04:37:05 +0000 UTC
