Kanto Region Gym Badges
Added 2023-01-20 01:03:43 +0000 UTCI lied, I said I would only do 5.... but there are 8 badges for Kanto, so I did them all and even added a pokeball one too. These have recess in the back for pins (Magnet ones listed below)
These should print fine in resin and FDM
No supports on FDM
Resin angle at 45 and light supports.
Now off to find more uses for these.
Comments
I am working on a case for these, It will be my next design after the ornamental metagross
Kenneth Loebenberg
2023-01-22 13:54:38 +0000 UTCthese are sick Ken, would it be possible to make an open/closing case like ash carried to print all the badges, put them in their respective slots and angle the door backwards to make it stand up and display or close it to put it in your pocket??
Josh
2023-01-22 03:05:27 +0000 UTCMy fear with splitting those was how small the parts would get. Especially for the FDM folks
Kenneth Loebenberg
2023-01-20 13:23:20 +0000 UTCGreat work But : cascade, pokeball, rainbow and earth (the nightmare) need to be split or be sure to have the paint job skill ...
AC-3D.Caen
2023-01-20 11:09:24 +0000 UTC
