Snorlax Valentines
Added 2022-02-04 15:06:21 +0000 UTCInstructions
I messed up i grabbed the wrong file for the body its fixed now
FDM
Use a lower percentage infill on the hearts
I suggest
15 for the body
5 for the heart
Resin
I would hollow it out and angle the body back
I would also keep the body hollow 2 times thicker than the heart
Ie
Body at 4mm
Heart at 1.5m to 2mm
If it falls over glue to base.
Comments
Ok. Thank you. I'll post it now.
Joanne Swarthout
2022-02-11 19:50:06 +0000 UTCThe best place to post those photos is the Facebook page ,patreon isn't really good about image uploads. Although it sounds like the STL file got damaged when you downloaded it. Could you post a photo of your slice and also of how it prints on the Facebook page
Kenneth Loebenberg
2022-02-11 16:29:03 +0000 UTCI'm having trouble with the top of the "I Choose You" heart. The top portion-opposite the bite mark-doesn't print all of the way. The top layer doesn't print completely. It stops and has a layer line and then the next layer to print starts the layer with the words. I don't know if I am explaining clearly. I took a picture. Is there a way to post the picture so you can see?
Joanne Swarthout
2022-02-11 16:08:48 +0000 UTCI am out of town the this weekend for my wife's birthday and have not updated the Dropbox. I'll be updating it in about 2 hours
Kenneth Loebenberg
2022-02-07 03:47:56 +0000 UTCsweet. thank you. i got into the dropbox too.
Roger bock
2022-02-07 03:46:49 +0000 UTCYes I took the bad one down yesterday
Kenneth Loebenberg
2022-02-07 03:45:39 +0000 UTCis this the fixed version?
Roger bock
2022-02-07 03:42:09 +0000 UTCYes. Is there a problem with it
Kenneth Loebenberg
2022-02-05 18:37:00 +0000 UTCwas the other hand also supposed to get a cutout cause the hearts not holding
Joel Rivera
2022-02-05 18:32:44 +0000 UTC
