Reworked pokeball
Added 2021-11-25 01:05:48 +0000 UTCNow with better fit and a new hinge
Also I have attached my pre-supported files. These worked for me but you may have different luck
updated the inner rings
Update - just added the solid ball that does not open
Comments
Do you think you would return to this project and change the fire emblem or potentially add more variations for each of the pokemon types?
Max Spiteri
2022-09-08 13:34:20 +0000 UTCThis reminds me of the stone boxes in shining pearl, if you ever decide to make another pokemon box you should make those!
YarnWitch
2021-12-28 02:26:23 +0000 UTCThere was an issue with the inner rings, I fixed them both
Kenneth Loebenberg
2021-12-17 03:26:18 +0000 UTCSounds good thanks
Scott Morris
2021-12-17 02:12:04 +0000 UTCI already commented on it, give me a half hour and I'll check it and on my side. It may be a damaged file
Kenneth Loebenberg
2021-12-17 02:11:38 +0000 UTCStill getting the same thing posted on Facebook with a image
Scott Morris
2021-12-17 02:10:47 +0000 UTCIf you continue to have issue please post a pic of the slice over on the Facebook page and it will be easier to help with.
Kenneth Loebenberg
2021-12-17 01:35:48 +0000 UTCOK I'll try that thanks
Scott Morris
2021-12-17 01:30:18 +0000 UTCI would use .12. that is what it is designed for.
Kenneth Loebenberg
2021-12-17 01:29:40 +0000 UTC.2
Scott Morris
2021-12-17 01:28:52 +0000 UTCWhat layer height are you using?
Kenneth Loebenberg
2021-12-17 01:28:32 +0000 UTCHaving a issue with the inner ring b when I slice it with Cura I keep getting a area halfway up separating it and 2 parts with a gap missing between the 2 parts
Scott Morris
2021-12-17 01:27:36 +0000 UTCI like this a lot, I would say the one half detail is less raised than the other, making the detail harder to paint on that side. I'd prefer less of it, and more raised like the other half.
Nick Smith
2021-11-28 16:16:33 +0000 UTChas anyone had an issue with the hinge the first one I did was fine but the second was not. Not sure if it was lucky on the first or print error on the second
Kenneth Loebenberg
2021-11-27 22:12:23 +0000 UTCOk thank you
Roger bock
2021-11-27 16:07:22 +0000 UTC
