Ornamental Gengar
Added 2021-10-04 00:18:53 +0000 UTC
Comments
can these be made on FDM printers? I'm learning ....may invest in resin sooner than later though
alex salabarria
2023-06-01 02:09:36 +0000 UTCyea i joined after finding on thing looks sick
Jordan Dmytryk
2022-01-14 22:35:13 +0000 UTCThanks for joining!
Kenneth Loebenberg
2021-11-23 03:22:55 +0000 UTCNice, it was a lot of fun to design
Kenneth Loebenberg
2021-11-23 03:22:24 +0000 UTCJoined for this one. You do some sick work bro
Josh
2021-11-23 02:34:41 +0000 UTCWe could do a discord or Facebook group. I would be good with ether. I'll set up a poll in a few days. It's a great idea.
Kenneth Loebenberg
2021-10-09 02:56:40 +0000 UTCyou got me with this one.
Jarrod Gallagher
2021-10-08 06:00:50 +0000 UTC@filaments folly maybe setup a discord ? We don't need a paid one but a free one where we can discuss prints could be cool
Stan Ziskand
2021-10-07 00:44:25 +0000 UTCI'm doing two printers and the bulbasaur was on a very well configured ender 3 while the hanger is on a sidewinder 2
Stan Ziskand
2021-10-07 00:43:46 +0000 UTCI'll start adding print settings for fdm printing when I post these. I always use .12 layer heights for my prints of this detail
Kenneth Loebenberg
2021-10-06 23:38:27 +0000 UTCI printed it the ornimwntals are a tad small and shallow in some areas I'm planning to print this again in 1.2mm lines and 10 percent fill
Stan Ziskand
2021-10-06 23:25:08 +0000 UTCWhelp, I know what I'm printing a couple dozen of.
Chops Worth
2021-10-05 23:56:36 +0000 UTCthanks!
Kenneth Loebenberg
2021-10-05 16:11:10 +0000 UTClooks great!
Stan Ziskand
2021-10-05 13:51:50 +0000 UTC
