Oups ... little delay
Added 2022-02-18 14:51:01 +0000 UTCWe have found a potential issue on the extruder, nothing that cannot be solved, and we prefer to check before sharing with you. We will not be able to share before next week unfortunately.
I have added a section regarding 602 issue in the post "BearExxa V2 - Gearing" here: https://www.patreon.com/posts/62425637 .
Do you have any questions regarding the extruder? Feel free to ask!
(emoji by https://openmoji.org , open source emoticon library)
Comments
Genuine Bondtech ones (this is what we used for development and testing as well). This is a very important part, tolerances are tiny so you don't want to have something random there. Our delay is actually due to tolerance between those two gears actually.
Grégoire Saunier
2022-03-01 22:45:50 +0000 UTCQuestion about the extruder: Do you have any suggested sources for the additional gears we need?
Matthew Humphrey
2022-03-01 22:40:08 +0000 UTCYes we have identified the issue and testing the improvement we made. This was an interesting one, I will write a post once we have finished the tests. I am glad we saw it before the launch.
Grégoire Saunier
2022-02-24 21:05:47 +0000 UTCIs the problem solving going the good way ? :)
Emeric Bréhaut
2022-02-24 19:06:37 +0000 UTC
