New Z Tops
Added 2019-10-06 17:21:15 +0000 UTCHere is a view of what the new Z tops will looks like.
- Both M5 screws are now in front to allow better alignment and improve print quality (reduce warping).
- Stiffer holding of the Z smooth rod thanks to deeper hole.
- Several improvement in the geometry to improve stiffness.
- More precise surface to improve accuracy when X axis is ramming into Z tops.
Comments
No because then you become dependent on the length of the extrusion and the angle of the cut. Both are very hard to get perfect because extrusion is melted aluminum and so it wraps, twist and shrink exactly like our printed parts. The Z smooth rods are more accurate than extrusions and so they are the best reference to use.
Grégoire Saunier
2019-10-07 07:17:26 +0000 UTCHave you thought about incorporating the cap into this piece?
Kyle Rothrock
2019-10-06 23:24:45 +0000 UTCSo cool! When this is released, I'm going to buy the extended Z kit from All3D Makers.
Joel Weinberg
2019-10-06 20:30:55 +0000 UTC
