Heated Bed Cable Clips
Added 2019-04-10 16:46:00 +0000 UTCI had to do something for my heated bed cables that were bending too much in my enclosure. I also switched to AWG14 which makes the original mount too small. Here is an exclusive design for you lovely exclusive patrons that has an angle of 55° and support 8mm sleeve for AWG14 wires.
Comments
Thanks for the feedback. Are those original connectors and bed (no clone)?
Grégoire Saunier
2019-06-20 05:44:59 +0000 UTCThe top part needs more room for the connectors and cables. It fit fine after some tender care with a soldering iron. ;)
JTa
2019-06-20 03:05:21 +0000 UTCOk will see if I can make them stronger but not a lot of room
Grégoire Saunier
2019-06-03 06:32:33 +0000 UTCI printed in PETG, and it broke because I put the opposite half on first then kind of tried to "force" the side with tabs on, and they didn't align with the gaps between my cables well enough so they snapped off.
Austin Vojta
2019-06-03 06:19:30 +0000 UTC
