Dragon Wiggle Keychains MODEL UPDATE
Added 2024-02-20 20:39:46 +0000 UTCHey everyone!
New updated version of the second model I ever made-- the Dragon Wiggle Keychain! Older members may remember this little guy. He's so cute and was a great seller for me when I sold my model prints before committing to just designing. Although he prints upright with a SUPER small print bed footprint so a lot of people have adhesion issues with him.
I wanted to do an updated version for y'all and everyone else who bought this file, so I'm super excited to finally release this little guy! I love how he turned out and I think it showcases my growth in 3D modeling and 3D print understanding so well. This guy has enough depth that he prints on his back which is a much more successful print orientation!
Copper print is printed at 0.1 layer height, multicolor dragon is printed at 0.2 layer height. Bambu 3MF file included for the new guy :).
Print recs:
*2-4 walls
*5-15% infill
*No supports
*Add brim if needed
*Print with adaptive layer heights for smoothest print quality
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
I hope y'all enjoy this guy!
Thanks so much for all your support <3
- Kek
EDIT: For those of you asking about scaling down for earrings, I just tested it at 70% (0.2 layer height so not as smooth as they could be) and it printed no problems! I probably wouldn't go much smaller and risk link strength but I think they'd be okay for earrings! :) (pics added to the end of the slides)
