Kekreations 3D

Decorative Dragon Egg EARLY ACCESS

Added 2023-11-07 21:27:30 +0000 UTC

Hey everyone,

It's been a long time coming but I finally got a pretty egg for y'all to use! I wanted to make sure I pushed these out early enough for y'all to pair with holiday sales :). Egg fits 2-3 of my baby dragons, depending on which ones you choose.

Print recs:
*2-3 walls
*10-15% infill
*Print at any size (Pictured is 100%, 75%, and 50%)
*No supports (If your printer struggles with the very top part of the top half of the egg, you can add a small tub of supports for the very tip. None of the testers felt they needed supports)

Model link: https://www.kekreationsart.com/patreonmod

Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

Hope y'all enjoy it!

Thanks so much for all your support <3

- Kek