Kekreations 3D

Haunted Dice Tower EARLY ACCESS

Added 2023-09-10 09:16:41 +0000 UTC

Hey everyone,

Time for more Halloween stuff! This time, the Haunted Dice Tower! A big print but a super fun one! Shoutout to the Discord community for helping me brainstorm this idea for Halloween! <3

Print recs:
* 2-3 walls
* 10-20% infill
* Can print down to 80% and still roll a standard 22mm D20
* No supports needed

Model link: https://www.kekreationsart.com/patreonmod

Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

Hope y'all enjoy this spooky model!

Thanks so much for all your support <3

- Kek

EDIT: An additional file with a couple of small modifications has been added to the zip download for this one! The stairs are pulled forward towards the door a bit more (to avoid the dice bouncing into the shadows), there's a flat landing spot for the dice to avoid the dice landing crooked, and I pulled out a few internal walls to cut down about an hour or two of print time. Feel free to use whichever version you prefer! <3

EDIT 2: New file in the ZIP has been updated again to fix a misalignment in some floor layers for the new version!