PRE-SUPPORTED FILES READY!
Added 2020-06-21 10:17:20 +0000 UTCHello friends! I have uploaded pre-supported files in June release folder on SYNC !
I have tested 99% of them and prints were fine! Will share some photos in few days!
There were several small fails in the process but this is most probably because of the printing settings i was using. After repeating the same print with the same supports no issues appeared :) I believe there wasn't enough exposure time for curing the resin, so no problems with supports.
Have fun printing! and really hope it will help to save your time!
In case some fails appear sorry :) i did my best to make good supports. With time quality will increase for sure :)
Big thanks to Nicholas Taylor who helped me with advises in the process!
Have a great weekend! I am back to sculpting!
Alexei
Comments
Hi Ryan ill make sure to have it pre-supported soon!
Alexei Popovici
2020-06-22 05:57:03 +0000 UTCKnow its not part of this months release but would it be possible to get a pre-supported version of the welcome pack, undead knight is amazing but struggling to get it properly supported
Ryan Fitzpatrick
2020-06-21 18:26:03 +0000 UTC
