The 3 ring body design continues.. for the 500mm guys!
Added 2018-08-11 06:36:24 +0000 UTC
Comments
Where are these located on the onedrive. Awesome work
Kevin Volo
2018-10-09 21:55:41 +0000 UTCI'd like to suggest making the data panel and charge bay panel backs as separate installable pieces. This makes the sanding and painting a lot easier as there would be less interior corners to navigate with a sanding block.
Timothy Hebel
2018-09-13 05:44:36 +0000 UTCMe too I guess that I will have to cut these in half to be able to print them.
Joseph Masci
2018-09-06 02:39:42 +0000 UTCI'm hoping this will be ready when my new dome finishes printing ;)
Peter Richards
2018-09-03 04:40:14 +0000 UTCThey could be, yes :-)
Michael Baddeley
2018-08-28 20:32:09 +0000 UTCCould these be sliced in quarters to fit on a 300mm bed?
Harold Harmon
2018-08-28 16:43:14 +0000 UTCThanks Peter, the lower ring is virtually there, got some work to do on the other two but getting closer.
Michael Baddeley
2018-08-28 04:34:30 +0000 UTCIf you need anyone to test those files for you... :D
Peter Richards
2018-08-28 01:48:09 +0000 UTCwhere in the folder is located? ha nvm. i just read that it is being tested.
C.PZO
2018-08-25 04:20:49 +0000 UTCI really wish i made my diy printer 500 instead of 400, oh well
Brendon Buhler
2018-08-22 02:16:15 +0000 UTCYes it will. Each ring printed separately should fit nicely. I have printed 4 R2 domes on mine so far. All had plenty of room. The rings and the domes are the same diameter.
2018-08-21 15:50:06 +0000 UTCWill a CR-10-S5 able to print this ? i know build size is 500 x 500 x 500 but im not sure if its possible to use and print properly the entire print bed size
2018-08-21 14:21:52 +0000 UTCFantastic, and welcome !! Post a pic of your printer on the community page, love to see it :-)
Michael Baddeley
2018-08-21 06:54:18 +0000 UTC
