Domes, domes and updates
Added 2018-07-02 08:02:09 +0000 UTCWell, we’ve four single print domes now available for all you CR10 s5 users! R2, R4, R5, R7 all done. R9 and R6 to follow shortly. I’ve also ordered a couple of motors to test the centre leg lift mechanism. I’ve got a brushless and a brushed dc drill motor. If the drill motor struggles, then we’ll move to the brushless. Finally just started work on a three ring body for the big printer folks. That’s a 4 part body, 3 body rings and the skirt. 4 threaded rods run through the rings for strength. Bit slow this weekend as I had to rebuild my Prusa (mk2s upgrade) and Ive got the 2.5 upgrade to go.
Happy printing,
Mike,
Comments
My R4 dome: <a href="https://www.instagram.com/p/Bm3AIq1lYgn/?taken-by=r2djp" rel="nofollow noopener" target="_blank">https://www.instagram.com/p/Bm3AIq1lYgn/?taken-by=r2djp</a>
2018-08-24 13:02:06 +0000 UTCstill looking for the r6 dome files
Mad-sec
2018-08-02 14:10:17 +0000 UTCGreat now I want a CR 10 because 4 3D printers are not enough 8*)
Joseph Masci
2018-07-14 18:56:24 +0000 UTCI am so looking forward to the 4 part body design!
Peter Richards
2018-07-04 03:20:36 +0000 UTCwhere can i download the files?
2018-07-02 20:02:21 +0000 UTCI'm really looking forward to hearing the results of motorising the center mechanism.
Ray Edgley
2018-07-02 14:25:07 +0000 UTCUnfortunately they built R2 a little bigger at 450mm :-( hence to s5
Michael Baddeley
2018-07-02 08:12:12 +0000 UTCdoes a cr10s4 fall under the big printer name :p?
Jeroen De Boeck
2018-07-02 08:09:08 +0000 UTC
