Final post of the evening.
Added 2017-09-03 20:54:02 +0000 UTCWe have the gripper arm and both utility arm servos installed and running from the Adafruit 16 channel controller. Instructions will be shared this week in the Patreon early bird share! Enjoy.
Mike,
Comments
Hi, I don't have a full BOM list, there's recommendations in the instructions on a module by module basis. M4 bolts, nuts and square nuts are my standard fitting however I bought a couple of boxes of various bolts and small self tapping screws. 6mm and 8mm threaded rods are used or the foot drives along with 6mm and 8mm bearings. I know people are using different fixings as the design can be fixed in many different ways and metric / imperial differ by country.
Michael Baddeley
2017-09-13 04:52:00 +0000 UTCHi, do you have a BOM with all screws, bolts, etc used on your project?
2017-09-12 15:43:38 +0000 UTCShould work, just need to remap the keys.
Michael Baddeley
2017-09-08 21:53:15 +0000 UTCi am planning to use the SHADOW drive system with 2 PS3 move controllers if i remap the sounds would i be able to make it do what yours does?
The Coined Box
2017-09-08 16:11:50 +0000 UTCWonderful. Thank you.
Todd Walden
2017-09-06 16:51:41 +0000 UTCSimplify3d
Michael Baddeley
2017-09-06 04:31:19 +0000 UTCJust out of curiosity, what slicer do you use?
Todd Walden
2017-09-05 23:43:11 +0000 UTClooking very neat!
Geoffro / Hex3D
2017-09-05 05:15:31 +0000 UTC<a href="https://www.thingiverse.com/thing:2211836" rel="nofollow noopener" target="_blank">https://www.thingiverse.com/thing:2211836</a>
Michael Baddeley
2017-09-04 04:30:02 +0000 UTCI did do a cut down version on Thingiverse which should fit a standard CSR build (no integrated skins). Not tested it personally as I have only built fully printed ones.
Michael Baddeley
2017-09-04 04:28:50 +0000 UTC
