July set feasibility feedback
Added 2021-07-02 16:10:40 +0000 UTCUpdate 06.07.2021 - Pose 1 torso is fixed. Now it should assemble without any issues.
I have uploaded ZIP archive in the core folder + separate files in “Pose 1” folder.
Have a happy printing!
Dear Patrons!
While test-printing July set with my old, not very accurate, resin, i've found that Pose 1 might be hard to assemble (rifle stock clashes with body in area around right hand and shoulder).
Could you please share your feedback with me (and other patrons, why not) in the comments to this post or in direct message?
If you run into same problem, i'll modify the body models early next week!
Hope you'll have a splendid weekend anyway!
Comments
You mean in the area I've told about? I guess i'll have to look into it tomorrow then! Thanks for feedback!
Stas
2021-07-05 17:41:06 +0000 UTCI tested print today, Pose 1 got some hand problem. Printed at XY-110 Z-100, the outcome was great.
Joel
2021-07-05 17:37:34 +0000 UTCThey definitely are! I've sculpted them to be compatible with Spectre and Empress ranges of metal minis, so they are thinner (and a bit lower, but i'll keep it in mind and make next release a bit taller) than WG ones.
Stas
2021-07-05 04:52:49 +0000 UTCThe models look smaller compare to bolt action figure.
Joel
2021-07-05 02:38:25 +0000 UTC
