Switch Spinning Storage Container
Added 2024-02-02 21:05:43 +0000 UTCThis is a super fun print, and can be very profitable as well. Spinning the games is very satisfying and it randomizes your game if you can't decide what you want to play. This design was complicated to get dialed in, but it finally works great!
Components you'll need to order.
1. The Magnets: Small Round Magnets (Amazon) (same magnets as all other prints)
You'll need 22 magnets per spinner
2. Bearings: Fidget Spinner Bearings (Amazon)
You need just 1 bearing per spinner
3. Stick on Rubber Base (Optional): 58mm Anti-Slip Silicone (Amazon)
You need just 1 per spinner
Comments
Which magnets are loose? The magnets in the slots should be loose. But the magnets in the base shouldn’t be loose. Any magnets in the base need to be secure, adding super glue will be fine that’s what you need to do
ForgeCore Co
2024-02-13 20:40:55 +0000 UTCHey, in the assembly video you say what to do if the magnets are too tight, but will it still work if they fit loosely? I do not have any adhesive that will not damage the magnets if directly applied.
2024-02-13 20:32:44 +0000 UTCYeah They’re based off how long it takes me to print them on my Bambu Lab
ForgeCore Co
2024-02-13 15:51:29 +0000 UTCJust wondering if your print time estimates are based on the Bambu Lab printer and the speeds you set in your slicer? I usually set my infill and wall speeds to 120 for my Ender 3 V3SE and I get no less than 6 hours for all three parts.
Barry Beach
2024-02-13 15:42:36 +0000 UTC3D gloop
ForgeCore Co
2024-02-06 03:28:39 +0000 UTCwhat kind of glue did you use for the disk, my magnets keep popping the disk loose and getting all stuck together
SkysThLimit
2024-02-06 03:26:52 +0000 UTCThe files for the disc are in the same sections as the rest of the STL files!
ForgeCore Co
2024-02-05 02:20:45 +0000 UTC
