Desktop Basketball
Added 2024-01-08 23:28:25 +0000 UTCDesktop Basketball is a super fun way to pass the time when you need a break from your work. It works with any standard ping pong ball and can adjust to fit any size desk.
Additional Components You'll Need:
1. Ping-Pong Balls: Standard Balls (Amazon) or Basketball Style Balls (Amazon)
2. Small Metal Screws: Can pretty much use any screw that is short. No need to buy anything specific
Assembly Instructions:
1. Screw the Rim into the backboard with metal screws.
2. Install the Net into the Rim. You may need to mess around with the angle you insert it, and flex the plastic a little to get it installed.
3. Install the Clamp Screws into the Clamps
4. Slot the finger into one clamp & Slot the pole into the other clamp.
5. Slot the backboard onto the pole. You're Done!
Comments
Using Cura Slicer, when I load the clamp stl it automatically scales it to 100,000% of its original size and it wont let me change it back to 100%?
2024-01-13 20:32:13 +0000 UTCNope, no supports
ForgeCore Co
2024-01-10 22:45:25 +0000 UTCDo you print the backboard with supports? to go around the pole insert?
2024-01-10 22:45:08 +0000 UTCHow big is your build plate?
ForgeCore Co
2024-01-10 02:49:46 +0000 UTCI recently started using Orca Slicer. I loaded the backboard onto the plate and was warned something like the file had unconventional dimensions and aske if I wanted to convert to millimeters. I said yes and the file loaded. It was upright and bigger than the plate. I then loaded the same file into Cura and it loaded to be about 17x24 mm in size. What did I do?
Barry Beach
2024-01-10 02:49:17 +0000 UTC
