How to Build Abraxia, With Tips!
Added 2024-05-28 21:19:57 +0000 UTCThis large video shows the whole process of building and cleaning up the new Abraxia model from Games Workshop in preparation for painting. I go over lots of little tips and tricks to hide join lines, remove mould lines etc.
The following equipment was used:
Godhand clippers, Tamiya Extra Thin, Sprue Glue, Scalpel, Tamiya Sanding Sponge
Comments
Hmm, I use milliput on resin too. I tend to overfill the areas and then sand it smooth. You can also overfill the area then use a large, damp brush to smooth the sides before leaving it to dry and then sand.
Richard Gray
2024-06-02 20:42:55 +0000 UTCThanks for this Richard; can’t wait until they make her available as a single model. Do you have any advice on gap filling resin miniatures? Sprue glue makes plastic so easy: just apply, dry and sand until seam is invisible. With resin, even when the Milliput looks flush I always discover that it isn’t after priming. Cheers!
Rob Cass
2024-05-29 15:19:23 +0000 UTC
