Update Modular File
Added 2024-05-10 21:43:05 +0000 UTCHey Guys if you downloaded the Modular Hydroponic System when it was in Version 11, Update it to version 14
The bayonet was a few degrees off perfect and it annoyed me.
Fixed now.
If you're already printing it's not a problem that you need to worry about, just change over for future prints.
Comments
If you click the address bar where your files are located, hit CMD to open command prompt in this current directory. Then hit tar -xf "NameOfZipFolder.zip". That will unzip the contents into the current folder. Use -C "DestinationFolder" to specify output folder. It must exist before using the command argument -C
Tom Bailey
2024-11-02 21:34:42 +0000 UTCI disabled the Anti virus and still no luck with downloading the files. Just and empty zip file
C Wheeler
2024-06-21 01:55:01 +0000 UTCSometimes my Anti Virus software will cause this
Tom Bailey
2024-06-20 17:01:33 +0000 UTCcan someone point me in the direction to the new files I am getting an empty zip file
C Wheeler
2024-06-11 02:31:10 +0000 UTCIs there a way to do this free standing? Like without being attached to a wall?
Justin lewis
2024-05-26 22:45:42 +0000 UTCThere's an addon in cura called mesh tools that lets you divide the parts.
Justin Dail
2024-05-16 01:41:32 +0000 UTCHi Hoocho, I am not shore what I am doing wrong when I down load the Modular Hydro system file, I am getting all the files in one, is there a folder with all the parts sepearated as a STL file for each part?
Terry Traeger
2024-05-14 10:36:23 +0000 UTCWhere do you buy your petg from?
Torben
2024-05-11 02:28:19 +0000 UTC
