Maleficent's Dragon (Clean Variant)
Added 2024-02-02 15:43:54 +0000 UTCThe first version of the dragon is now all ready to download below! I've set the model at 17cm tall which makes her a couple of cm bigger than our Lotso model. She should print fine on resin or FDM but a drain hole is recommended for the end of her tail to prevent suction issues and organic supports are recommended for her spikes and mouth.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
ORGANIC SUPPORTS / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues let me know! The ornamental version will be out in a couple of days!
See you in the next post,
Harley
Comments
Not at the moment but he's in your 6 month folder under the 'shared with me' tab on google drive
PoisonApplePrints
2025-02-18 17:40:07 +0000 UTCIs this available anywhere else
Michelle
2025-02-18 14:59:08 +0000 UTCSo exciting 🙌🏻
Sonja Oswalt
2024-02-02 20:11:07 +0000 UTC
