Partnership with Atlas 3D Support Solutions
Added 2020-10-31 17:54:54 +0000 UTCAs you probably know, this is our first experience with Patreon, and we are very grateful for your patience and valuable advice.
Thanks to you, we have enlisted the support of Atlas, who will be in charge of supporting all models for the November release!
In addition, we are now working on the launch of our Discord channel where communication with our team and other Patrons will be way easier and more fun!
We apologize for some difficulties during the first day of the launch. As always, we're happy to hear any question or advice from you!
Comments
Very delighted to hear that! I sent your kind words to Atlas3D team as well.
Signum Workshop
2020-11-05 13:27:08 +0000 UTCThese supports are amazing! After a rant on Twitch about alot of "pre-supported" patreons and they're really bad and really not worth the time saving you get as the fails are a bigger waste of time and resin its really nice to see some supports that are near perfect, Good job peeps!
Dammitt Daniel
2020-11-05 13:15:36 +0000 UTCThat's also true. My only problem with Atlas is some models definitely seem to not be tested as there are very clear deficiencies in models that require updates throughout the month. Those models are all but guaranteed failures prior to their updates or the user including additional supports. When at atlas model is ACTUALLY ready it prints beautifully. I guess there's no perfect support out there, ha ha. I do agree some of gregs are a bit too "much" at times as well.
Shawn Michaud
2020-11-02 04:49:42 +0000 UTCI prefer atlas supports to gregs. gregs may not fail often, but they often scar the model. with atlas, the supports leave the model clean. would much rather have to make sure my printer is super dialed in and have clean sculpts, then have scaring.
Incandescent Dragon Creations
2020-11-02 04:44:41 +0000 UTC
