Kahled - WIP
Added 2021-08-04 20:27:27 +0000 UTCHello everyone!
Sharing with you guys my next release is still in the block-out phase. Kahled is a Hunter! A DPS for our Draenei party.
He will have a Crossbow and Short sword. As options, he will have that blade I made for Bahsuur but never released, so it will come, also there will be a Hand pointing (to make command beast pose). I know that in wow Hunter uses Mail armor but for him, I will give a Leather armor, and maybe I will add some plating.
As a variation for him, I will add a cloak covering his right shoulder and head.
Kahled will also be accompanied by his Pet Bodum. Bodum is an Armored Baby Elekk.
I know it sounds clichΓͺ but I have added a rock under his foot...
Leave a comment if I should change a pose, hair, or perhaps you have an idea.
Offtopic:
Barendal - The character prints well and I had no problems but, the basing is consuming a lot of time, I printed 1 ok and since I printed another Barendal I had to print another base, and that's where the problems started. I Added more supports let's see how it goes. Once I finish the print I will officially release him.
32mm Draenei Bases - I had a lot of successful prints and then I printed again to finish basing the Draenei I have printed... from 3 bases had 1 failure, so I added more supports and I'm test printing again.
50.8mm Dirt Base (Elekks basing) - I have successfully printed 1 base and went to print the rest, They failed, so I have to add more supports.
Overall I am learning a lot adding supports on the miniatures and it has been a great experience but, once I have more people join Patreon I will pay for supporting because this way I could invest my time sculpting more models instead of dealing with print failures.
Best Regards,
Ivo
Comments
Sure, no big deal. I could also add a hand with some bolts
2021-08-05 02:10:17 +0000 UTCI supported and printed two Barendal bases myself (still very new to supporting) just to see how they would come out. I found the forgiving thing about the bases is you can put a couple medium or heavy thick supports on the bottom and it wont destroy any detail because its the bottom. Uses more resin, but less likely to fail. Re: Hunter: I like where he is going, I like both the armored Elekk and the cloak idea. Can I suggest an empty right hand also? I'm weird and I like to leave my archers offhands empty for realism haha
BigKittyPaints
2021-08-05 02:08:44 +0000 UTCYou where the first person that came to my mind.
2021-08-04 21:14:24 +0000 UTCNice! DJ Khaled xD Haha he's looking awesome though Ivo, great stuff brother. And you know where I am for supporting π
Fraser
2021-08-04 20:53:09 +0000 UTC
