Sega megadrive/genesis controller on its way
Added 2019-12-25 21:12:25 +0000 UTCHappy holidays everyone!!! Just finished populating and labeling the panel for the sega genesis controller. It’s got all the controls for 4 fm operators then a knob to switch between the separate instruments and poly mode! algorithm select/fm feedback etc And also buttons for preset write and recall. Hopefully by end of the week will have it all wired out and give it a go. Hopefully all works nicely and makes a good vid :) will share the plans!
Have a lovely day!
Comments
No protection! I have used lots of arduinos in projects and the only time it has broken is if it is driving too much. I’ve never had an arduino not work from over voltage to modular amounts. But maybe it’s an over time effect? Either way I don’t think I’ll be using the cv inputs enough to justify the extra faff. 😁
Look Mum No Computer
2019-12-27 09:16:28 +0000 UTCExcellent design choice! Any protection for CV above 5V or negative? I'm assuming it's going almost directly to an Arduino-like analog input pin.
Antoine Alary
2019-12-27 00:45:23 +0000 UTCYep. It’s setup as the 5v on the pot is switched to the jack. So when a jack plugged in the pot just acts as an attenuators. Nothing complicated in this one! I Just why not! Only 1 extra wire!
Look Mum No Computer
2019-12-26 23:46:29 +0000 UTCFrom my understanding only operator 1 feedsback! Apparently. From what I have looked into it. But I’m sure I’ll be able to tell when adjusting hopefully and then rectify. I think I will he making adjustments here and there after it’s wired!
Look Mum No Computer
2019-12-26 23:45:24 +0000 UTCYou forgot to indicate which operator gets the feedback in the algorithm diagrams.😛 (Unless it's always on the same one on this machine.)
Antoine Alary
2019-12-26 05:49:04 +0000 UTCCV in on everything!?!
Antoine Alary
2019-12-26 05:44:01 +0000 UTC
