Workshop done, starting on motor frame for leg lift
Added 2018-07-15 09:57:18 +0000 UTCQuite a lot of work in the last few weeks, mainly rebuilding my printer, fixing the other one and moving everything to my new build workshop outside (previously in the dining room).
Got my motors now also, so I’m just printing the first test of the mounting frame and gearing for the centre leg lift. The printer issues have slowed this down a little but fingers crossed we’re back at full speed.
Comments
Was just wondering if it was this one.. <a href="https://www.thingiverse.com/thing:2212749" rel="nofollow noopener" target="_blank">https://www.thingiverse.com/thing:2212749</a> I ask as I made an updated design you might be intertedted in. Its hard to see from tyhe picture. :)
2018-07-15 20:36:36 +0000 UTCNice. I tried this, but my work shed has no heat and not insulated very well. Even with an enclosure, it would get too cold at night (during the winter) and my multi-hour prints kept failing - had to move everything into the house.
LarryJ
2018-07-15 14:08:32 +0000 UTCHi Martin, it’s a IKEA LACK table enclosure. Check out Thingiverse, there’s a few designs to print to convert two LACK tables. (They’re only £6 each!)
Michael Baddeley
2018-07-15 10:48:21 +0000 UTC
