Drive gear printed and tested.
Added 2017-07-10 21:22:19 +0000 UTCDrive gear, drive motor bracket, slip ring bracket and cabling support all done and tested. I've just got some soldering to do now! Note these designs are not posted at the moment because my phone lines and internet is down. I'll pop them up as soon as I can! Damn BT...
Comments
Uau! It's a big one.. mine it's only 35mm diameter.. I'll have to adapt somehow I think...
2017-07-14 23:52:22 +0000 UTCThe link is <a href="http://www.maplin.co.uk/p/mfa-45-15v-large-501-single-ratio-motor-gearbox-n99bn" rel="nofollow noopener" target="_blank">http://www.maplin.co.uk/p/mfa-45-15v-large-501-single-ratio-motor-gearbox-n99bn</a>
Michael Baddeley
2017-07-14 22:31:06 +0000 UTCMike.. what's the size of the motor you're using??
2017-07-14 22:10:22 +0000 UTCIt is indeed. The files are from the bb8 builders club. They are superb.
Michael Baddeley
2017-07-14 16:14:41 +0000 UTCIs that BB8 I seen the backgorund? 3d Printed? What model did you use for that?
2017-07-14 16:11:25 +0000 UTCupsss.thanks!! printing right now... thaks!
2017-07-14 11:05:39 +0000 UTCHi, new folder in Patreon share called DomeDrive. They're in there.
Michael Baddeley
2017-07-14 10:04:44 +0000 UTChi!! cant find the files.. WIP /gear is empty... thanks!!
2017-07-14 10:01:32 +0000 UTCIt is a 6 wire set up, the hole in the centre though can be adjusted easily and it's a single piece which has the hole in as part of the structure so send across any sizes and I'll change accordingly. Takes seconds.
Michael Baddeley
2017-07-12 03:56:40 +0000 UTCAwesome
Illuminati Games
2017-07-12 01:25:41 +0000 UTCWhat size (diameter) slip ring is this designed for? I'm only able to count 5 wires, but I'm guessing this is a 6 wire setup?
LarryJ
2017-07-12 00:39:48 +0000 UTC
