Merry Xmas & Happy Holidays 🎄
Added 2021-12-25 22:48:07 +0000 UTCMerry Xmas & Happy Holidays to you all!!! 🎄
Here the prints of some of the 👻 Necropolis 💀 miniature bases (25mm & 32mm).
Probably my exposure settings need a fix (sorry all😅) so to print the pre-supported models I added some extra medium supports below on the edges where there were too many empty spot as well in spread in the middle of the model too (lower part) --> 15 minutes to prepare 4 models 😉
🔸So if you'd like to print some, please check be sure your setting are fine or add some more support just to be sure to improve the chance of a good print.
More news on Monday from the printing service!!!
BTW, since I'd like to paint them tomorrow but I still have few ideas how... I'd like to know which would be your favourite color scheme and which paints you'd pick up to paint these four bases 😁
Thank you!!!
Cheers
Jack
Comments
Added a new print, the 50mm_A base 😁
Jack (Admiral_Apocalypse)
2021-12-26 23:26:31 +0000 UTCHi all!!! Pre-supported files could be fine rather my exposure setting are to low so supports have not enough time to cure and make them stronger. I will increase it and see what happens😁
Jack (Admiral_Apocalypse)
2021-12-26 12:03:19 +0000 UTC
